How to Operate your Thermo Cyclopad

Powering Up

Press the Power Switch [11] to turn the device on. The first Timer Indicator LED will be illuminated indicating that the timer

is set to ten minutes.

By pressing the Timer Switch [4] Up once, the time will be increased by ten minutes and the next LED will be illuminated. Each

press of this switch will increase the time by ten minutes to a maximum of one hour.

By pressing the Timer Switch Down once, the time will be decreased by ten minutes and the top LED will be extinguished.

Each press of the switch will decrease the time by ten minutes until the device is switched off.

By pressing the Massage Mode Switch [9] the mode of massage can be varied from Standard to Tranquilssage (T/S) or

Cycloid Poly Modulation (CPM).

Unless the device has been left switched off with preset massage positions, pressing the Massage Mode Switch will switch

the device on in the Standard mode.

By pressing the Intensity Switch [3], the intensity of the cycloid vibration therapy can be increased and decreased.

If the device switches off by running the timer to zero, the mode and massage intensity settings will be saved. Therefore the

next time the device is switched on it will automatically assume these settings.

The Thermo Cyclopad heater [10] can be activated using the Heater Switch. The heater does not have a save function and

will need to be switched on when required.

The Remote Signal Strength LED [1] will flash if the communication between the Remote Control and the Thermo Cyclopad

is poor. If communication is lost completely, after two minutes both the Remote Control and the Thermo Cyclopad will switch

off automatically.

The Low Battery LED will flash when the Remote Control batteries need replacing. This LED [5] will only flash when the

Thermo Cyclopad is running (on), and will not work when the batteries are completely exhausted.

To turn the Thermo Cyclopad off before the timer has reached zero, simply press the Power Switch [11] once.